A study of the coordination behaviour of the lanthanide series with oxygen-donor ligands
- Authors: Kuhn, Kirsti
- Date: 2012
- Subjects: Chemical elements , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:10394 , http://hdl.handle.net/10948/d1009533 , Chemical elements , Chemical reactions
- Description: The reactions between the lanthanide nitrate salts and the ligand triphenylphosphine oxide (TPPO) gave rise to nine-coordinated complexes of the nature Ln(TPPO)3(NO3)3, for Ln = La – Dy, Er, Tm, in which the Ln(III) centre is coordinated to three phosphoryl oxygen atoms and three bidentate nitrate ligands. Generally, the geometry can be described as being mer-octahedral, where the nitrate ligands are considered as monoatomic species. The product of the reaction between Yb(NO3)3·5H2O and TPPO, however, was a highly symmetrical eight-coordinated complex, in which the Yb(III) centre was coordinated to two bidentate nitrate groups and four TPPO molecules. The geometry in this case is best described as being trans-octahedral, with the two nitrate ligands coordinated practically perpendicular to one another. The complexes isolated from the reactions of lanthanide nitrate salts with the ligand bis(pentamethylene)urea (PMU) had the general formula Ln(PMU)3(NO3)3, where Ln = La – Dy, Yb, Lu. The complexes were found to be nine-coordinated with distorted trigonal prismatic geometry, in which the one base of the prism is composed of the oxygen atoms of the three PMU ligands and the other base is made up by one oxygen atom from each of the bidentate nitrate groups. The second oxygen atoms of each of the nitrate groups protrude upward, occupying capping positions. The reactions of the La and Pr nitrate salts with the ligand 2,2’-dipyridyl-N,N’-dioxide (DPDO) produced two novel complexes of the nature [Ln(DPDO)(H2O)2(NO3)3]. These complexes are remarkable in that their crystal structures reveal the Ln(III) centres to be ten-coordinated. The geometry around the Ln(III) centres was complex, due to the presence of a seven-membered chelate ring, formed by the bidentate coordination of the oxygen atoms from the DPDO ligands to the metal centres. The chelate ring did not lie in a single plane, but was twisted at the pyridyl bridgeheads to lie above and below the coordination plane.
- Full Text:
- Date Issued: 2012
- Authors: Kuhn, Kirsti
- Date: 2012
- Subjects: Chemical elements , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:10394 , http://hdl.handle.net/10948/d1009533 , Chemical elements , Chemical reactions
- Description: The reactions between the lanthanide nitrate salts and the ligand triphenylphosphine oxide (TPPO) gave rise to nine-coordinated complexes of the nature Ln(TPPO)3(NO3)3, for Ln = La – Dy, Er, Tm, in which the Ln(III) centre is coordinated to three phosphoryl oxygen atoms and three bidentate nitrate ligands. Generally, the geometry can be described as being mer-octahedral, where the nitrate ligands are considered as monoatomic species. The product of the reaction between Yb(NO3)3·5H2O and TPPO, however, was a highly symmetrical eight-coordinated complex, in which the Yb(III) centre was coordinated to two bidentate nitrate groups and four TPPO molecules. The geometry in this case is best described as being trans-octahedral, with the two nitrate ligands coordinated practically perpendicular to one another. The complexes isolated from the reactions of lanthanide nitrate salts with the ligand bis(pentamethylene)urea (PMU) had the general formula Ln(PMU)3(NO3)3, where Ln = La – Dy, Yb, Lu. The complexes were found to be nine-coordinated with distorted trigonal prismatic geometry, in which the one base of the prism is composed of the oxygen atoms of the three PMU ligands and the other base is made up by one oxygen atom from each of the bidentate nitrate groups. The second oxygen atoms of each of the nitrate groups protrude upward, occupying capping positions. The reactions of the La and Pr nitrate salts with the ligand 2,2’-dipyridyl-N,N’-dioxide (DPDO) produced two novel complexes of the nature [Ln(DPDO)(H2O)2(NO3)3]. These complexes are remarkable in that their crystal structures reveal the Ln(III) centres to be ten-coordinated. The geometry around the Ln(III) centres was complex, due to the presence of a seven-membered chelate ring, formed by the bidentate coordination of the oxygen atoms from the DPDO ligands to the metal centres. The chelate ring did not lie in a single plane, but was twisted at the pyridyl bridgeheads to lie above and below the coordination plane.
- Full Text:
- Date Issued: 2012
The reactions of ruthenium (ii) polypyridyl complexes
- Authors: Zheng, Sipeng
- Date: 2009
- Subjects: Ruthenium , Ruthenium compounds , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:10374 , http://hdl.handle.net/10948/1089 , Ruthenium , Ruthenium compounds , Chemical reactions
- Description: Ruthenium (II) polypyridine complexes in general have been extensively studied because of their unique redox and photochemical properties. A typical example of such complexes is tris(2,2’-bipyridyl) ruthenium (II). In this study, this complex was synthesized and then characterized using electronic spectroscopy and cyclic voltammetry. It was also shown that the ruthenium concentration could be accurately determined using ICP-MS. It was found that the complex is very stable in various chemical environments. It was observed from spectrophotometric investigations that persulphate and lead dioxide easily oxidize Ru(bpy)3 2+ to Ru(bpy)3 3+ in the presence of heat and H2SO4, respectively. It was also observed that the oxidation between Ru(bpy)3 2+ and cerium (IV) occurred at approximately 3:2 [Ce(IV)]/[Ru(II)] mole ratio. The resultant Ru(bpy)3 3+ solution was unstable in the presence of light and recovery of Ru(bpy)3 2+ occurred gradually. The regeneration of Ru(bpy)3 2+ from Ru(bpy)3 3+ was found to be a multistep process, which appears to involve the formation of an intermediate species. The following reaction model was found to best explain the kinetic data obtained: Ru(bpy)3 2+ + Ce(IV) → Ru(bpy)3 3+ Ru(bpy)3 3+ → Ru(bpy)3 2+ Ru(bpy)3 3+ → Ru* intermediate Ru* intermediate → Ru(bpy)3 2+ Theoretical rate constants were also calculated for the same process under the experimental conditions. The comparison between the experimental and theoretical results gave good agreement. In addition, the factors that influence the rate of the regeneration of Ru(bpy)3 2+ from Ru(bpy)3 3+ were also discussed.
- Full Text:
- Date Issued: 2009
- Authors: Zheng, Sipeng
- Date: 2009
- Subjects: Ruthenium , Ruthenium compounds , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:10374 , http://hdl.handle.net/10948/1089 , Ruthenium , Ruthenium compounds , Chemical reactions
- Description: Ruthenium (II) polypyridine complexes in general have been extensively studied because of their unique redox and photochemical properties. A typical example of such complexes is tris(2,2’-bipyridyl) ruthenium (II). In this study, this complex was synthesized and then characterized using electronic spectroscopy and cyclic voltammetry. It was also shown that the ruthenium concentration could be accurately determined using ICP-MS. It was found that the complex is very stable in various chemical environments. It was observed from spectrophotometric investigations that persulphate and lead dioxide easily oxidize Ru(bpy)3 2+ to Ru(bpy)3 3+ in the presence of heat and H2SO4, respectively. It was also observed that the oxidation between Ru(bpy)3 2+ and cerium (IV) occurred at approximately 3:2 [Ce(IV)]/[Ru(II)] mole ratio. The resultant Ru(bpy)3 3+ solution was unstable in the presence of light and recovery of Ru(bpy)3 2+ occurred gradually. The regeneration of Ru(bpy)3 2+ from Ru(bpy)3 3+ was found to be a multistep process, which appears to involve the formation of an intermediate species. The following reaction model was found to best explain the kinetic data obtained: Ru(bpy)3 2+ + Ce(IV) → Ru(bpy)3 3+ Ru(bpy)3 3+ → Ru(bpy)3 2+ Ru(bpy)3 3+ → Ru* intermediate Ru* intermediate → Ru(bpy)3 2+ Theoretical rate constants were also calculated for the same process under the experimental conditions. The comparison between the experimental and theoretical results gave good agreement. In addition, the factors that influence the rate of the regeneration of Ru(bpy)3 2+ from Ru(bpy)3 3+ were also discussed.
- Full Text:
- Date Issued: 2009
Asymmetric α-alkylation reactions
- Authors: Klein, Rosalyn
- Date: 2000
- Subjects: Asymmetric synthesis , Alkylation , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:4405 , http://hdl.handle.net/10962/d1006710 , Asymmetric synthesis , Alkylation , Chemical reactions
- Description: A novel camphor-derived hydroxy ketal 138 has been developed as a crural auxiliary, and used to prepare a series of six carboxylic esters of increasing steric bulk. The α-benzylation of this series of esters was achieved with diastereoselectivities of 59 - 83％ d. e. and in 39 - 48％ material yield. These results compared very favourably with those obtained in earlier studies using a regioisomeric analogue as the chiral auxiliary. Computer.modelling studies of the putative enolate intermediate has provided some insight into the possible mode of electrophilic attack at the α-carbon and the roles of the ketal protecting group and the lithium cation in these asymmetric transformations. In a related investigation, based on earlier work, a camphor-derived imino lactone has provided convenient access to α-alkyl α-amino acids, the imino lactone serving as a masked glycine equivalent. Using straight chain primary alkyl iodides [RI; R = Me, Et, Pr, Bu, CH₃(CH₂)₄ and CH₃(CH₄)₅], alkylation of the potassium enolate of the camphor-derived imino lactone was effected with 54 - 89％ d.e. and in 54 - 87％ material yield. Four novel alkylated derivatives were synthesised using isopropyl iodide, sec-butyl iodide and allyl iodide, the latter reagent resulting in both the monoallylated and diallylated products. While very good diastereoselectivities were achieved (83 - 88％ d. e.) in these reactions, the material yields from reaction with the secondary alkyl iodides were low (31- 35％) due, presumably, to their decreased electrophilicity. Computer modelling studies of the enolate were carried out and support the hypothesis of endo attack by the electrophile on the enolate intermediate. These studies also indicate the possibility of coordination of the postassium cation to the endocyclic ester oxygen, thus effectively anchoring the bulky cation away from the reaction site.
- Full Text:
- Date Issued: 2000
- Authors: Klein, Rosalyn
- Date: 2000
- Subjects: Asymmetric synthesis , Alkylation , Chemical reactions
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:4405 , http://hdl.handle.net/10962/d1006710 , Asymmetric synthesis , Alkylation , Chemical reactions
- Description: A novel camphor-derived hydroxy ketal 138 has been developed as a crural auxiliary, and used to prepare a series of six carboxylic esters of increasing steric bulk. The α-benzylation of this series of esters was achieved with diastereoselectivities of 59 - 83％ d. e. and in 39 - 48％ material yield. These results compared very favourably with those obtained in earlier studies using a regioisomeric analogue as the chiral auxiliary. Computer.modelling studies of the putative enolate intermediate has provided some insight into the possible mode of electrophilic attack at the α-carbon and the roles of the ketal protecting group and the lithium cation in these asymmetric transformations. In a related investigation, based on earlier work, a camphor-derived imino lactone has provided convenient access to α-alkyl α-amino acids, the imino lactone serving as a masked glycine equivalent. Using straight chain primary alkyl iodides [RI; R = Me, Et, Pr, Bu, CH₃(CH₂)₄ and CH₃(CH₄)₅], alkylation of the potassium enolate of the camphor-derived imino lactone was effected with 54 - 89％ d.e. and in 54 - 87％ material yield. Four novel alkylated derivatives were synthesised using isopropyl iodide, sec-butyl iodide and allyl iodide, the latter reagent resulting in both the monoallylated and diallylated products. While very good diastereoselectivities were achieved (83 - 88％ d. e.) in these reactions, the material yields from reaction with the secondary alkyl iodides were low (31- 35％) due, presumably, to their decreased electrophilicity. Computer modelling studies of the enolate were carried out and support the hypothesis of endo attack by the electrophile on the enolate intermediate. These studies also indicate the possibility of coordination of the postassium cation to the endocyclic ester oxygen, thus effectively anchoring the bulky cation away from the reaction site.
- Full Text:
- Date Issued: 2000
- «
- ‹
- 1
- ›
- »